Configure The Device To Accept Location Messages From External Sources - Digi IX14 User Manual

Services
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to accept location messages from external
sources
You can configure the IX14 device to accept NMEA and TAIP messages from external sources. For
example, location-enabled devices connected to the IX14 device can forward their location
information to the device, and then the IX14 device can serve as a central repository for this location
information and forward it to a remote host. See
information about configuring the IX14 device to forward location messages.
This procedure configures a UDP port on the IX14 device that will be used to listen for incoming
messages.
Required configuration items
The location server must be enabled.
n
UDP port that the IX14 device will listen to for incoming location messages.
n
Access control list configuration to provide access to the port through the firewall.
n
To configure the device to accept location messages from external sources:

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX14 User Guide
Forward location information to a remote host
Location information
for
365