Area Guidelines For Switch Installation On Flat Surface - Enterasys A2H124-24FX Hardware Installation Manual

Caution: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.
Do not connect the switch to the AC power source until instructed to do so later in the
installation process.
Precaución: Para asegurar una buena ventilación y evitar que el sistema se
sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y
a la parte posterior del aparato.
No conecte el dipositivo a la fuente primaria hasta que no se le indique.
If you are installing several switches in a stack, proceed to "Connecting Stacking Cables"
on page 3‐11. If the switch is being installed as a standalone switch, proceed to
"Connecting AC and RPS‐SYS Power" on page 3‐16 for power connection instructions.
Figure 3-5

Area Guidelines for Switch Installation on Flat Surface

À
1 Approximately 152 cm (5 ft) from power source
2 4.45 cm (1.75 in.) per switch. (Vertical clearance
depends on number of switches stacked.)
Ã
Installing the Switch on a Flat Surface
Â
3 44.5 cm (19.4 in.) for proper ventilation
4 41.9 cm (16.5 in.) for proper ventilation
SecureStack A2 Installation Guide
Á
3-9