Setting The Bootp Relay Threshold; Setting The Bootp Hop Count Limit - 3Com CoreBuilder 2500 User Manual

Setting the BOOTP
Hop Count Limit
Default
Top-Level Menu
system
ethernet interface
fddi
route
display
atm arp
define
bridge atmArpServer
remove
multicast
ip
hopCountLimit
ipx udpHelper
threshold
appletalk
routing
interface
snmp icmpRouterDiscovery
analyzer ospf
script
rip
logout ping
statistics
Setting the BOOTP
Relay Threshold
Top-Level Menu
system
ethernet interface
fddi route
display
atm
arp
define
bridge atmArpServer
remove
multicast
ip
hopCountLimit
ipx udpHelper
threshold
appletalk routing
interface
snmp
icmpRouterDiscovery
analyzer
ospf
script rip
logout
ping
statistics
You can set the maximum hop count, that is, the maximum number of
times that packets will be forwarded within the router. The range is
0 through 16 hops.
The default hop count setting is 4.
To set the hop count limit:
1 From the top level of the Administration Console, enter:
ip udpHelper hopCountLimit
2 Enter the BOOTP relay hop count limit.
You can set the maximum time limit for routing a packet. If you use 0 as
the value, the router does not process the value in the seconds field. If
you use a nonzero value, the router uses that value along with the hop
count value to determine whether to forward a UDP packet.
To set the BOOTP relay threshold:
1 From the top level of the Administration Console, enter:
ip udpHelper threshold
2 Enter the BOOTP relay threshold.
Administering UDP Helper 10-17