Configuring The User Interface; Reboot Ethernet Switch - 3Com 7700 Configuration Manual

12 C 1: S A
HAPTER YSTEM CCESS
Configuring the User
Interface
Figure 13 Dial the Remote PC
4 Enter the preset login password on the remote terminal emulator and wait for the
prompt.
<SW7700>
5 Use the appropriate commands to configure the Switch 7700 or view its running
state. Enter to get the immediate help. For details on a specific command, refer
?
to the appropriate chapter in this guide.
Note: By default, after login, a modem user can access the commands at Level 0.
User interface configuration is another way to configure and manage port data.
The Switch 7700 supports the following configuration methods:
Local configuration through the console port
■
Remote configuration through Telnet on the Ethernet port
■
Remote configuration through a modem through the console port.
■
There are two types of user interfaces:
AUX user interface is used to log in the Ethernet switch through a dial-up
■
modem. A Switch 7700 can only have one AUX port.
VTY user interface is used to telnet the Ethernet switch.
■
Note: For the Switch 7700, the AUX port and Console port are the same port.
There is only the type of AUX user interface.
The user interface is numbered by absolute number or relative number.
To number the user interface by absolute number:
The AUX user interface is the first interface — user interface 0.
■
The VTY is numbered after the AUX user interface. The absolute number of the
■
first VTY is the AUX user interface number plus 1.