Administering Stp Bridge Parameters - 3Com LANPLEX 6000 User Manual

Top-Level Menu
system
ethernet
display
fddi
mode
tokenring
ipFragmentation
bridge
ipxSnapTranslation
ip
trFDDIMode
snmp
addressThreshold
analyzer
agingTime
script
stpState
logout
stpPriority
stpMaxAge
stpHelloTime
stpForwardDelay
srBridgeNumber
port
packetFilter
Administering
STP Bridge
Parameters
Enabling/Disabling
STP on a Bridge
Default value
Top-Level Menu
system
display
ethernet
mode
fddi
ipFragmentation
tokenring
ipxSnapTranslation
bridge
trFDDIMode
ip
addressThreshold
snmp
agingTime
analyzer
stpState
script
stpPriority
logout
stpMaxAge
stpHelloTime
stpForwardDelay
srBridgeNumber
port
packetFilter
To set the bridge aging time:
1 From the top level of the Administration Console, enter:
bridge agingTime
2 Enter the number(s) of the slot(s) or
3 Enter the aging time value.
You can enable or disable Spanning Tree on one or more bridges and set
the following STP bridge parameters: priority, maximum age, hello time, and
forward delay. For more information about how the Spanning Tree
parameters interact at the bridge-level to create a loopless network, see
Chapter 5: Transparent Bridging in the LANplex 6000 Operation Guide.
You can enable and disable Spanning Tree on any bridge in the system.
When a bridge is disabled, it does not participate in the Spanning Tree
algorithm.
The default value is disabled.
To enable or disable Spanning Tree on one or more bridges:
1 From the top level of the Administration Console, enter:
bridge stpState
2 Enter the number(s) of the slot(s) or
3 Enter or
enabled disabled

Administering STP Bridge Parameters

for all bridges in the system.
all
for all bridges in the system.
all
at the prompt.
12-9