Ospf Mtu-Enable - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Example
# Bind MIB operation to OSPF process 100.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] ospf mib-binding 100
# Bind MIB operation to OSPF process 200.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] ospf mib-binding 200
# Cancel the binding of MIB operation.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] undo ospf mib-binding

3.1.35 ospf mtu-enable

Syntax
ospf mtu-enable
undo ospf mtu-enable
View
Interface view
Parameter
None.
Description
Use the ospf mtu-enable command to enable the interface to write MTU value when
sending DD packets.
Use the undo ospf mtu-enable command to restore the default settings.
By default, the MTU value is 0 when sending DD packets. That is, the actual MTU
value of the interface is not written.
Database Description (DD) packets are used to describe its own LSDB when the
router running OSPF protocol is synchronizing the database.
The default MTU value of DD packet is 0. You can use this command to configure the
specified interface manually to write the MTU value area in DD packets when sending
DD packets. That is, the actual MTU value of the interface is written in.
Chapter 3 OSPF Configuration Commands
3-41