Lifting The Robot; Orienting And Securing The Robot - ABB CRB 15000 Product Manual

3.3.2 Lifting the robot

3.3.2.1 Orienting and securing the robot

Introduction
This section describes how to lift the robot and transport it to the installation site.
Two persons are always required when lifting and securing the robot.
Do not leave the robot standing unfastened to the foundation, it is not stable on
its own.
Attachment screws
The table below specifies the type of securing screws and washers to be used for
securing the robot to the base plate/foundation.
All hardware is enclosed in the robot delivery.
Suitable screws
Quantity
Quality
Suitable washer
Guide pins
Tightening torque
Level surface requirements
Product manual - CRB 15000
3HAC077389-001 Revision: A
CAUTION
The manipulator must not be connected to power during lifting and securing it
to the foundation.
© Copyright 2021 ABB. All rights reserved.
3 Installation and commissioning
3.3.2.1 Orienting and securing the robot
M10x35
4 pcs
8.8
23/10.5/2.5 mm Steel
DIN6325, hardened steel Ø6x24 mm, 2 pcs
30 Nm ±10%
0.1/500 mm
Continues on next page
47