3 Installation and commissioning
3.3.3 Manually releasing the brakes
Continued
Supplying power to connector R1.MP
If the robot is not connected to the controller, power must be supplied to connector
R1.MP on the robot, in order to enable the brake release sensors.
1
2
52
Action
CAUTION
Incorrect connections, such as supplying
power to the wrong pin, may cause damage
to the electrical components.
Supply 0V on pin B and +48VDC on pin A.
© Copyright 2021 ABB. All rights reserved.
Note
xx2100000124
Product manual - CRB 15000
3HAC077389-001 Revision: A
+48VDC (A)
0V (B)