ABB CRB 15000 Product Manual page 515

3
4
5
Separating the cabling between the housing and the tubular
1
Product manual - CRB 15000
3HAC077389-001 Revision: A
Action
CAUTION
There is cabling connected between the cover
and the joint unit drive board.
Open the cover with care to avoid damage to the
cabling or the connector(s).
Do not leave the cover in location without being
secured with the attachment screws.
Open the cover and cut the cable tie that holds
the brake release cable.
Disconnect the brake release connector from the
drive board.
Remove the cover.
Action
Cut the cable ties.
© Copyright 2021 ABB. All rights reserved.
5.6.4 Replacing the axis-4 joint unit
Note
xx2000002022
xx2000002023
Note
xx2000002066
Continues on next page
5 Repair
Continued
515