General Procedures; Mounting Instructions For Sealings - ABB CRB 15000 Product Manual

Hide thumbs Also See for CRB 15000:

Table of Contents

5.2 General procedures

5.2.1 Mounting instructions for sealings

This section describes how to mount different types of sealings.

Rotating sealings

The procedure below describes how to fit rotating sealings.

Continues on next page

Please observe the following before commencing any assembly of sealings:

Protect the sealing during transport and mounting, especially the main lip.

Keep the sealing in its original wrappings or protect it well before actual

The fitting of sealings and gears must be carried out on clean workbenches.

Use a protective sleeve for the main lip during mounting, when sliding over

threads, keyways or other sharp edges.

Check the sealing to ensure that:

The sealing is of the correct type.

There is no damage on the main lip.

Inspect the shaft surface before mounting. If scratches

or damage are found, the shaft must be replaced since

it may result in future leakage. Do not try to grind or

polish the shaft surface to get rid of the defect.

Article number

3HAC042536-001

Shell Gadus S2

Product manual - CRB 15000

3HAC077389-001 Revision: A

Show Quick Links

Table of Contents