ABB CRB 15000 Product Manual page 104

5 Repair
5.3.2 Replacing the axis-1 cabling
Continued
Spare part
Cable harness, joint 1
Hex socket head cap flange screw
with glue
Cable tie
Required tools and equipment
Equipment
Guide pin, M4x120
Lifting aid
Protection plate
Cable tie gun EVO7
Standard toolkit
Required consumables
Consumable
Cable ties
O-ring, nitrile rubber
Grease
Cleaning agent
Flange sealant
O-ring
O-ring
Continues on next page
104
Article number
3HAC073204-001
3HAB3413-435
3HAC075545-001
Article number
3HAC077786-001
3HAC077788-001
3HAC077790-001
-
-
Article number
-
3HAB3772-64
3HAC042536-001
-
-
3HAC061327-044
3HAC061327-047
© Copyright 2021 ABB. All rights reserved.
Note
Also order new Cable tie:
3HAC075545-001.
M4x35, 12 pcs
Always use new screws when re-
fitting a joint unit. If ordering a
new joint unit spare part, new
screws are included.
For securing joint unit cable.
Note
Always use guide pins in pairs.
For joint units on axes 1, 2 and 3.
For joint units on axes 1, 2 and 3.
Attachment screws M4x35 (4 pcs)
are enclosed.
For protection of drive board
during cabling installation on joint
unit.
HellermannTyton 110-70084 or
similar
Content is defined in section
Standard toolkit on page 625.
Note
Base cover
Shell Gadus S2
Isopropanol
Loctite 574
Lower arm, inner cover. 1 pcs /
cover.
Replace if damaged.
Cover for axis 2/3
Replace if damaged.
Product manual - CRB 15000
3HAC077389-001 Revision: A