Maintenance And Repair - ABB CRB 15000 Product Manual

1 Safety

1.6.1 Maintenance and repair

1.6 Maintenance and repair
1.6.1 Maintenance and repair
General
Corrective maintenance must only be carried out by personnel trained on the robot.
Maintenance or repair must be done with all electrical, pneumatic, and hydraulic
power switched off, that is, no remaining hazards.
Make sure that there are no loose screws, turnings, or other unexpected parts
remaining after work on the robot has been performed.
When the work is completed, verify that the safety functions are working as
intended.
Hot surfaces
Surfaces can be hot after running the robot. Touching the surfaces may result in
burns.
Allow the parts to cool down before maintenance or repair.
Allergic reaction
Warning
Allergic reaction
Gearbox lubricants (oil or grease)
When handling oil, grease, or other chemical substances the safety information of
the respective manufacturer must be observed.
Risk of exceeding design life
Regular inspections, maintenance, and exchange of worn components are essential
to ensure the safe operation of this robot. Follow the instructions in section
Maintenance on page
Related information
See also the safety information related to installation and operation.
30
Description
When working with lubricants
there is a risk of an allergic reac-
tion.
Note
Take special care when handling hot lubricants.
77.
© Copyright 2021 ABB. All rights reserved.
Elimination/Action
Make sure that protective gear
like goggles and gloves are al-
ways worn.
Product manual - CRB 15000
3HAC077389-001 Revision: A