Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1237

2. Preparing for the Installation of the System Software
of Host machine
1. If both PC and the machine are on, turn them off.
2. Connect the PC and the host machine using an
Cross Ethernet cable. (when SST is used)
3. Turn on the PC.
3. Registering the system software
1. Insert the latest System Software into the PC using
the SST.
2. Start the SST.
3. Click 'Register Firmware'.
4. Select the drive where the system software has
been inserted, and click the [SEARCH] button.
5. Click the [REGISTER] button.
6. Click [OK].
4. Initializing HDD
<In case of SST>
1. Start the host machine with download mode in safe
mode.
2. Start the SST.
3. Select the model. Then, select [Single] and click
[Start].
4. Click [Format HDD].
5. Select [All], and click [Start].
6. Click [Execute Format].
7. The Format is executed.
8. Select [Shutdown/Restart], and click [Shutdown].
9. Click [OK]
10. The power of the host machine is turned OFF.
11. Terminate the SST.
12. Disconnect the Cross Ethernet Cable from the
machine, and connect the user's network cable to
the machine.
<In case of USB flash drive>
1. Connect the USB flash drive to the PC.
2. Start up SST, and click the USB icon displayed in
the target selection screen.
3. Select the drive, the model series, and the version
to be written to the USB flash drive, and click
[Confirm].
4. Click [Start], and after the version has been written
to the USB flash drive, click [OK] and then remove
the USB flash drive.
5. Terminate the SST.
6. Connect the USB flash drive to the host machine,
and start the host machine with download mode in
safe mode.
7. When the USB menu is displayed, press keys on
the Control Panel in the order shown below.
• [4]: Clear/Format
• [1]: Disk Format
• [0]: OK
• Press any keys.
• [C]: Return to menu
• [Reset] : Start shutdown sequence
• [0]: OK (The power of the host machine is
turned OFF automatically.)
8. Remove the USB flash drive.
9. Turn ON the main power switch.
■ Executing Auto Gradation
Adjustment
When the high-capacity HDD is installed, the machine
initializes its HDD, resetting the data used for auto gradation
correction.
Therefore, execute full adjustment of auto gradation
adjustment after installing the high-capacity HDD to enable
proper images to be output.
■ Execution of the Minimum
Installation Work
Be sure to execute the minimum installation work in
accordance with the Setup Guide because HDD is initialized
when the high-capacity HDD is installed.
1223
9. Installation