Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1281

■ HDD Initialization Procedure
1. Requirements
1. PC
Service Support Tool in the version that supports
this host machine must be installed.
2. Cross Ethernet Cable (when SST is used)
2. Preparing for the Installation of the System Software
of Host machine
1. If both PC and the machine are on, turn them off.
2. Connect the PC and the host machine using an
Cross Ethernet cable. (when SST is used)
3. Turn on the PC.
3. Registering the system software
1. Insert the latest System Software into the PC using
the SST.
2. Start the SST.
3. Click 'Register Firmware'.
4. Select the drive where the system software has
been inserted, and click the [SEARCH] button.
5. Click the [REGISTER] button.
6. Click [OK].
4. Initializing HDD
<In case of SST>
1. Start the host machine with download mode in safe
mode.
2. Start the SST.
3. Select the model. Then, select [Single] and click
[Start].
4. Click [Format HDD].
5. Select [All], and click [Start].
6. Click [Execute Format].
7. The Format is executed.
8. Select [Shutdown/Restart], and click [Shutdown].
9. Click [OK]
10. The power of the host machine is turned OFF.
11. Terminate the SST.
12. Disconnect the Cross Ethernet Cable from the
machine, and connect the user's network cable to
the machine.
<In case of USB flash drive>
1. Connect the USB flash drive to the PC.
2. Start up SST, and click the USB icon displayed in
the target selection screen.
3. Select the drive, the model series, and the version
to be written to the USB flash drive, and click
[Confirm].
4. Click [Start], and after the version has been written
to the USB flash drive, click [OK] and then remove
the USB flash drive.
5. Terminate the SST.
6. Connect the USB flash drive to the host machine,
and start the host machine with download mode in
safe mode.
7. When the USB menu is displayed, press keys on
the Control Panel in the order shown below.
• [4]: Clear/Format
• [1]: Disk Format
• [0]: OK
• Press any keys.
• [C]: Return to menu
• [Reset] : Start shutdown sequence
• [0]: OK (The power of the host machine is
turned OFF automatically.)
8. Remove the USB flash drive.
9. Turn ON the main power switch.
■ Setting the Mirroring
1. Make a setting of mirroring.
• Specify "1" under "Service Mode (Level 1) >
COPIER > OPTION > FNC-SW > W/RAID".
2. Turn OFF/ON the main power of the host machine to
enable the setting value.
3. Make sure that the UI screen is activated correctly.
4. Open the Cover, and make sure that the LED blinks.
NOTE:
Rebuilding starts approximately after 3 minutes after
turning OFF and then ON the power.
• HDD 1 (Slot 1): The green LED blinks.
• HDD 2 (Slot 2): The green and red LEDs blink.
1267
9. Installation