14 | English
ards that you may not hear whilst op-
erating the leaf blower/garden va-
Do not over reach and keep your bal-
ance at all times.
Always be sure of your footing on
Walk, never run.
Keep all cooling air inlets clear of
Never blow debris in the direction of
Do not carry the product by the
The wearing of a face mask is recom-
Wait until all product components
have completely stopped before
touching them. The fan continues to
rotate after the product is switched
off and can cause injury. Disconnect
supply cord from mains.
Do not modify the product. Unau-
thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
When in vacuum mode, objects
other than leaves and garden waste,
as stipulated in the Intended Use,
could be collected.
Do not vacuum solid objects such as
big branches, broken glass, pieces of
metal and stones.
A worn fan or blower housing (chips,
cracks, nicks) may cause an in-
creased risk of injury from thrown
F 016 L94 042 | (14.02.2020)
foreign objects. If the fan or blower
housing are damaged, consult the
In rare cases (e.g. prolonged use in
hot, dry conditions) a blower va-
cuum can generate an electrostatic
charge, that may be felt on contact
with the product.
Remove the plug from the socket:
– Whenever you leave the product
– Before checking, clearing a block-
age or working on the product
– After a collision with a foreign ob-
ject. Inspect the product for dam-
age and make repairs as necessary
– If the product starts to vibrate ab-
normally (check immediately)
Connecting to the mains
The voltage of the power source
must correspond with the data on
the type plate of the product.
We recommend that this product is
only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA resid-
Only use or replace power supply
cables for this product which corres-
pond to the types indicated by the
manufacturer. Contact the Service
Centre to do this.
Never touch the mains plug with wet
Do not run over, crush or pull the
power supply cord or extension
cord, otherwise it may be damaged.
Bosch Power Tools