Configurations; Datashelf - Mitel SX-200 Practices

Peripheral Devices
Configurations
17.1 A DATASHELF 9100 and a Modem lnterconnnect Panel are available for mounting
within the DATACABINET 9000. This Part describes different configurations that can
be set up within the cabinet. Configurations are restricted only by the 35 inch height
limit of the 19 inch rack and the total heights of the equipment being installed on it,
The DATASHELF 9100 is 8.75 inches high, and the Modem Interconnect Panel is 3.5
inches high. Instructions for installing each assembly into the DATACABINET 9000
are k-r Table 17-2.
The -DATACABINET 9000, configured with three DATASHELF 9100 assemblies and
,one Modem Interconnect Panel, is shown in Figure 2-l.
Equipment within the DATACABINET 9000 is to be powered only from the internal ac
distribution panel. No external ac line cords are to be brought into the cabinet.
The DATACABINET 9000 must always have the fan unit installed in the bottom of the
cabinet.
Table 17-I lists the possible configurations and equipment quantities which are
available for a DATACABINET 9000.
Table 17-l ATACABINET 9000 Configurations
1 Equipment Configuration / DATASHELF 9100 1 Modem Interconnect Panel
1 1 -
2 I 1
3 2 -
4 2 1
5 2 2
6 3 -
DATACABINET 9000 Installation and Wring
17.2 Unpack the DATACABINET 9000 and check it for damage or missing items. Position
the cabinet where it is to be installed and equipped. Install the shelves and cables
within the cabinet according to Table 17-2.
126 17-4
Revision 0
9109-096-12CNA
Issue1