Setting The Switch's Ip Address - Huawei Quidway S1700 Series Web User Manual

Quidway S1700 Series Ethernet Switches
Web User Manual
Table 3-1 Parameters of "System > General" Information
Title
System Description
System Up Time
System Name
System Location
System Contact
System Jumbo Frame
System EEE
1. Click System > General.
2. Specify the system name, location, and contact information for the system administrator,
enable or disable system jumbo frame and system EEE.
3. Click Apply.
----End

3.2 Setting the Switch's IP Address

Use the System > IP page to configure VLAN and an IPv4 address for management access
over the network.
At default, the device obtains an address from DHCP server. If failed to obtain IP address, a
static address of 192.168.0.1 will be assigned.
To obtain a dynamic address through DHCP for the switch:
1. Click System > IP.
2. Select the VLAN through which the management station is attached, set the IP Address Mode
to "DHCP".
3. Click Apply to save your changes.
4. Then click Restart DHCP to immediately request a new address.
Issue 01 (2011-11-17)
Description
Brief description of device type
Length of time the management agent has been up.
Name assigned to the switch system
Specifies the system location.
The contact information of the administrator
Enable or disable system jumbo frame. (default:disabled)
Enable or disable system EEE. (default:disabled)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
3 System Management
12