Electrical Connections; Robot Cabling And Connection Points - ABB IRB 7600 Series Product Manual

2.7 Electrical connections

2.7.1. Robot cabling and connection points

Introduction
Connect the robot and controller to each other after securing them to the foundation. The lists
below specify which cables to use for each respective application.
Main cable categories
All cables between the robot and controller are divided into the following categories:
Cable category
Robot cables
Position switch and fan cables
(option)
Customer cables (option)
External axes cables (option)
1)
The cable categories are divided into sub-categories, specified below.
Robot cables
These cables are included in the standard delivery. They are completely pre-manufactured
and ready to plug in.
Cable sub-category Description
Robot cable, power
Robot cable, signals
3HAC022033-001 Revision: K
工控帮助教小舒QQ2823408167
Description
Handles power supply to and control of the robot's motors as
well as feedback from the serial measurement board.
Specified in the table
Handles supply to and feedback from any position switches
and cooling fans on the robot.
Specified in the table
base to controller (option) on page
Handles communication with equipment fitted on the robot
by the customer, including databus communication, low
voltage signals and high voltage power supply + protective
ground.
See the product manual for the controller
Handles power supply to and control of the external axes'
motors as well as feedback from the servo system.
See the Application manual - Additional axes and stand
alone controller (M2004)orApplication manual - External
axes (M2000)
Art. no. is specified in section
Transfers drive power from the
drive units in the control cabinet
to the robot motors.
Transfers resolver data from
and power supply to the serial
measurement board.
2 Installation and commissioning
2.7.1. Robot cabling and connection points
Robot cables on page
Position switch and fan cables, robot
1)
.
References on page 10.
Connection
point, cabinet
XS1
XS2
133.
134.
1)
.
Connection
point, robot
R1.MP
R1.SMB
Continues on next page
133