ABB IRB 7600 Series Product Manual page 308

4 Repair
4.5.2. Replacement of brake release unit
Continued
3. Connect the connectors X8, X9 and X10 to the
4. Refit the SMB cover with its attachment screws. Shown in the figure
5.
6. Refit the push button guard on the SMB cover. Shown in the figure
7. If the battery has been disconnected the
8.
306
工控帮助教小舒QQ2823408167
Action
brake release unit.
WARNING!
Before continuing any service work, please
observe the safety information in section
WARNING - The brake release buttons may be
jammed after service work on page
revolution counters must be updated.
DANGER!
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in the section
test run may cause injury or damage! on page
47.
Note
xx0200000129
A. Connector X8
B. Connector X9
C. Connector X10
D. Push buttons
release unit, frame on page
48!
release unit, frame on page
Detailed in section
counters on page
DANGER - First
3HAC022033-001 Revision: K
Location of brake
302.
Location of brake
302.
Updating revolution
408.