ABB IRB 7600 Series Product Manual page 323

Required equipment
Equipment, etc.
Press tool, balancing device
Hydraulic cylinder
Hydraulic pump, 80 MPa
Standard toolkit
Using the correct press device
The different designs of the balancing device require different versions of the press device,
included in the complete press tool. The table below specifies which press device to use to
which balancing device.
The article number of the balancing device may be found on a label at the rear of the balancing
device.
Balancing device
xx0300000605
Art. no: 3HAC14675-2
xx0700000423
Art. no: 3HAC023018-001
3HAC022033-001 Revision: K
工控帮助教小舒QQ2823408167
4.5.5. Unloading the balancing device using hydraulic press tool.
Art. no.
3HAC020902-001
3HAC11731-1
3HAC13086-1
-
4 Repair
Continued
Note
Includes
• press device 3HAC15767-2
• press device 3HAC18100-1
Choose the correct device, depending
on model of balancing device.
To be used with the press tool.
To be used with the hydraulic cylinder.
Content is defined in section
toolkit on page 427.
Press device
xx0300000600
Art. no: 3HAC15767-2 (for balancing
device 3HAC14675-1)
xx0300000599
Art. no: 3HAC18100-1 (for balancing
device 3HAC023018-001)
Continues on next page
Standard
321