EM−122
Mark
1, 2, 3, or 4
Plastigage
Less than 6 mm
ENGINE MECHANICAL (1GR−FE)
(c)
NOTICE:
Do not apply engine oil to the bearing or its contact surface.
HINT:
A number marked on each main bearing cap indicates the
installation position.
(d)
A23052
(e)
A23053
(f)
(g)
(h)
A23054
(i)
A23055
(j)
(k)
A23056
−
CYLINDER BLOCK
Align the bearing claw with the claw groove of the main
bearing cap, and push in the 4 bottom bearings.
Place the crankshaft on the cylinder block.
Lay a strip of Plastigage across each journal.
Examine the front marks and numbers and install the
bearing caps on the cylinder block.
Apply a light coat of engine oil to the threads of the bear-
ing cap bolts.
Temporarily install the 8 main bearing cap bolts to the in-
side positions.
Install the main bearing caps. Tighten the 2 bolts for each
bearing cap until the clearance between the bearing cap
and the cylinder block becomes less than 6 mm (0.23 in.).
Using a plastic−faced hammer, lightly tap the bearing cap
to ensure a proper fit.
Apply a light coat of engine oil to the threads of the main
bearing cap bolts.