Assembly Of Transmission - Toyota Celica Supra 1986 Service And Repair Manual

•
.
AUTOMATIC TRANSMISSION - Assembly of Transmission
AT -105
A SSEMBlY OF TRANSMISSION
Disassembly. inspection and assembly of each com-
ponent group have been indicated in the preted·
lng chapter. This chapter deals with assembly of
A430E
transmission.
GENERAL ASSEMBLY NOTE:
1.
The automatic transmission is composed of
highly
prec i sion ~fin i shed
parts, necessitating
careful inspection before assembly because
even a small nick could cause fluid leakage or
affect performance.
3. Before assembling new clutch discs, soak
them in automatic transmission fluid for at
feast two hours.
S.
Apply automatic transmission fluid on sliding
or rotating surfaces of the parts before
as·
sembly.
7. Use petroleum jelly to keep the small parts in
their places.
Front ......
A
8
c
0
E
Before assembly. make sure again that all compo-
nent groups are assembled correctly. If something
wrong is found in a certain component group dur·
ing assembly, inspect and repair this group im-
mediately.
2. Do not use adhesive cements on gaskets and
similar parts.
4 . When assembling the transmission, be sure to
use new gaskets and 0 -rings.
6 . Dry all parts by blowing with compressed air.
Never use shop rags.
8. Be sure to install the thrust bearings and races
in the correct direction and position.
F
G
H