Toyota Celica Supra 1986 Service And Repair Manual page 501

BR-24
-·
.-
~~
BRAKE SYSTEM - Rear Brake
......
"'*'
l llose3
3. ME.ASURE ROTOR DISC RUNOUT
(a) Temporaril y install the hub nuts in reverse.
(b) Measure the rotor disc runout at 10 mm (0.39 in.)
from the outer edge of rotor disc.
Maximum runout: 0.15 mm (0.0059 in.}
If the runout is greater than the maximu m, replace tho
disc .
4. IF NECESSARY, REPLACE ROTOR DISC
(a) Remove the torque plate from the rear axle housing.
(b)
Remove t he rotor disc and hub nuts.
(c)
Install the rotor disc, and adjust the shoe
clearanct~
(d) Install the torque plate onto the rear axle housing.
Torque: 475 kg.cm
(34
ft·lb, 47 N-m)
ASSEMBLY OF CYLINDER
(See
page
BR-20}
1. APPLY LITHIUM SOAP BASE GLYCO L GREASE
TO FOLLOWING PARTS:
(a) Main pin boot
(b) Sliding pin and boot
(c) Piston seal and piston
(d)
Dust boot
2. INSTALL PISTON SEAL AND PISTON IN CYLINDER
3. INSTALL CYLINDER BOOT AND SET RING IN
CYLINDER