Toyota Celica Supra 1986 Service And Repair Manual page 332

•
AUTOMATIC TRANSMISSION - Component Groups
IOverdri~e Input Shaft and Clutch! AT-57
"'"
13.
REMOVE ONE-WAY CLUTCH FROM OUTER RACE
Note the direction of the one-way clutch.
INSPECTION OF OVERDRIVE INPUT SHAFT AND
CLUTCH
1. INSPECT CLUTCH PISTON
(al Check that check ball is free by shaking the piston.
lbl Check that the valve does not leak by applying low-
pressure compressed air.
2. INSPECT DISC, PLATE AND FLANGE
Check that the sliding surface of disc is not worn or burnt.
If the disc
is worn or burnt, replace d isc.
Then check that the sliding surfaces of plate and flange
are not worn or burnt.
If
necessary.
replace them.
NOTE: Do not allow the discs to dry out.
Prepare new d iscs by soaking them at least two hours in
ATF.
ASSEMBL V OF OVERDRIVE INPUT SHAFT AND
CLUTCH
(See pege AT -551
1. INSTALL FOUR PLUGS
2 . INSTALL THRUST WASHER AND B. E ARING
(a I Coat parts with petroleum jelly to hold them in place.
l ~~~~~----=::.--~J
lbl Slide bearing and then thrust washer facing lip
c;.m
outward.
3. ASSEMBLE ONE-WAY CLUTCH
(a) Install the one-way clutch into t he outer race.
(bl Install a retainer on both sides of the one-way clutch.
"""