Toyota Celica Supra 1986 Service And Repair Manual page 81

00
~
Nut Nut
Bolt Length
ENGINE ,.,ECHANICAL - Cylinder Block
EM-119
20
20
20
mm
6. INSTALL ROD BEARING CAPS
(al Match the numbered cap with the numbered rod.
(b) Align the marks pvnched on the rod and cap and tight·
en the cap nuts to specified torque ahernately in two
or three passes.
Tor-: 450 kg-em (33
ft~b.
44 N·ml
(c) After tightening the caps, check that the crankshaft
rotates smoottlly.
8. MEASURE ROD THRUST CLEARANCE
(See atap 18
on -
EM-431
7 . INSTALL OIL PUMP ASSEMBLY
(a) Clean tho oil pump.
8.
9.
10.
11.
12.
13.
(b) Install the oil pump and holding bolt.
Tor que the bolt.
Torque: 220 kg-em (16
ft~b.
22 N·ml
(c,
Install the oil pipe with gasket, lock washer and un·
ion bolt. Tighten the oil pipe nut and bolt.
Tor-: 360 kg-em (25 ft·lb, 34 N·ml
INSTALL OIL PUMP DRIVE SHAFT
While turning
the
drive shaft, slowly insert so as not to
damage the drive shaft bearing.
Torque tho bolt.
Tor-: 130 kg·cm (9 ft~b . 13 N •ml
INSTALL REAR OIL SEAL RETAINER
INSTALL TIMING BELT CASE WITH WATER PUMP
lal
Position a new gasket on the cylinder block.
(b) Install the timing belt case
with eight boll$ and two
nuts.
Torque:
8 mm bolt
and nut
186 kg-em
(13ft-lb. 18 N·ml
10 mm bolt 375 kg-em
(27
ft~b.
37 N·m)
INSTALL OIL PAN
(See page LU-71
INSTALL WATER BY-PASS PIPE
INSTALL FUE. L HOSE SUPPORT