Toyota Celica Supra 1986 Service And Repair Manual page 403

PR·S
Matks
(
J'-
I
Front ._, -
.
~-
1
I
( ·)
PROPE LLER SHAFT- Propeller Shaft
-
"""
,..,.,
Bracket
Center Line
f.
" 'Center of
Center Buring
INSTALLATION OF PROPELLER SHAFT
(See
page PR·3)
1. INSERT YOKE IN TRANSMISSION
(a) Remove SST from the transmission.
SST 09325-20010
(b) Push the yoke into the transmission.
2. CONNECT PROPELLER SHAFT FLANGE TO
COMPAN ION F LANGE ON DIFFERENTIAL
(a) Align the marks on the flanges and connect the
fla nges with four bolts and nuts.
(b) Torque the bolts and nuts.
Torque: 430 kg-em (31 ft·lb, 42 N-m)
3. CONNECT CE NTER SUPPORT BEAR ING TO BODY
(a) Place a height spacer between the body and center
support bearing, and install the two mounting bolts
finger tight.
NOTE: Some vehicles do not have a spacer. In this case,
it is not necessary to insert one.
(b) Check that the bearing bracket is at right angle to
the propeller shaft. Adjust the bracket if necessary.
(c) Check that the center line of the center bearing is sol
to the center line of the bracket when the vehicle is in
a no-load condition. Adjust the bracket if necessary.
(d) Torque the mounting bolts.
Torque: 410 kg-em (30 ft-lb, 40 N·m l