Toyota Celica Supra 1986 Service And Repair Manual page 239

CL-10
'''"
'""
CLUTCH -Clutch Unit
9. IF NECESSARY, REPLACE RELEASE BEARING
{a} Using a press and SST, press the release bearing
from
the hub.
SST 09315·00010
{b) Using a press and SST, press a new release bearing
into the hub.
SST
09315·00010
{c)
After installing the bearing, check that there is
no
drag on the bearing when it is turned under pressure.
INSTALLATION OF CLUTCH UNIT
{See
page CL· 7)
1. INSTALL DISC ON FLYWHEEL
Using SST, install the disc on the flywheel.
SST 09301·20020
2. INSTALL CLUTCH COVER
Tighten the bolts evenly and gfadually. Make several passes
around the cover until the cover is snug. Torque the bolts.
..
Torque: 185 kg-em {13 ft-lb, 18 N-m}
I
3. CHECK DIAPHRAGM SPRING TIP ALIGNMENT
Using a feeler gauge and SST, measure the gap between the
spring tips and the tool.
SST 09302·30031
Ma•imum gap: 0.5 mm {0.020 in.}
If
gap is excessive.
adjust as follows.
I