Toyota Celica Supra 1986 Service And Repair Manual page 537

STEERING - Powt>r Steering
DISASSEMBLY OF GEAR HOUSING
(See
page SR-271
1.
CLAMP GEAR HOUSING IN VISE
NOTE:
SR-29
( 1) The rack housing is made of aluminum, so always use
soft jaws on the vise and clamp onto the part shown
in the f igure.
2.
(21
If
clamping onto the center tube, wrap a piece of
cloth around it and be carefu I not to damage the
tube.
REMOVE TURN PRESSURE RIGHT AND LE FT
TUBES AND UNION SEATS
(a) Using SST, remove the turn pressure t ubes.
SST 09631 ·22020
(b) Remove the union seats.
3. REMOVE TIE ROD ENDS
(a) Place matchmarks on the tie rod end and rack end.
(b) Loosen the
clamp and remove the t ie rod end from
t he rack end.
4. REMOVE RACK BOOTS
5. REMOVE RACK GUIDE SPRING CAP LOCK NUT
Using SST, remove the rack guide spring cap l ock nut.
SST 09612·24012 (096 17·24020)
6. REMOVE RAC K GUIDE SPRING CAP
Using SST, remove the rack guide spring cap.
SST 09612·24012 (09612·100211
7. REMOVE RACK GUIDE SPRING
8. REMOVE RACK GUIDE AND SEAT
9. REMOVE DUST COVER
10. REMOVE CONTROL VALVE HOUSING
(a) Place matchmarks on the control valve housing and
rack housing.
(b) Remove the three bolts.
(c) Remove the control valve housing.
(d) Remove t he O·ring.