Toyota Celica Supra 1986 Service And Repair Manual page 349

AT-74
AUTOMATIC TRANSMISSION - Component Groups !Center Support Assembly)
14. TURN CENTER SUPPORT OVER AND INSTALl NO. 2
BRAKE PlATES. DISCS AND FlANGE
Using
the
low -pressure compressed air. blow all
excess
All'
fro m the discs.
CAUTION: High·preuure air win damage the dlac.
Install in order: Plata-disc-plate-disc-plato-disc-flange lfllll
side down)
16. INSTAll SNAP RING IN CENTER SUPPORT
Check that the snap ring ends are not al igned wi th one of
the cutouts.
16. CHECK PISTON STROKE OF NO. 2 BRAKE
W ith a dial indicator. measure the sttoke applying llld
releasing the compressed air 14 - 8 kg/ em'. 57 - 114
psi or 392 - 785 kPa) as shown.
Standard piston ttroke: 1 .01 - 2.26 mm
(0.0398 - 0 .0888 ln.)
If the stroke exceed a the limit. the clutch peck is probably
worn. If the stroke is less than the limit, parts may be mls·
L--------- - ----'co=.,.:.o
assembled or there may be excess ATF on tho discs.
"'"
"""
17. ASSEMBLE CE. N TER SUPPORT AND SUN GEAR SHAFT
(a) Align the brake No. 2 disc fl ukes .
(bl Mesh t he brake hub w ith
the
discs, twisting and ja-
gling t he hub es required.
18. INSTALl SNAP RING ON END OF SUN GEAR SHAFT