Toyota Celica Supra 1986 Service And Repair Manual page 420

FRONT AXLE AND SUSPENSION - Front Suspension
FA·17
INSTALLATION OF LOWER ARM
1. INSTALL LOWER ARM IN CROSSMEMBER
2. CONNECT STABILIZER BAR AND STRUT BAR TO
LOWER ARM
(a)
Connect the stabilizer bar to the lower arm with the
bolt and nut. Torque the nut.
Torque: 180 kg·cm (13 ft·lb, 18 N·m)
(b) Connect the strut bar to the lower arm with the two
nuts. Torque the nuts.
Torque: 670 kg·cm (48 ft·lb, 66 N·ml
3. CONNECT KNUCKLE ARM TO BALL JOINT AND TIE
ROO
(al Install the knuckle arm on the ball joint with a nut.
Torque the nut and install a new cotter pin.
Torque: 800 kg-em (58 ft·lb, 78 N·ml
(b) Install the knuckle arm on the tie rod with a nut.
Torque the nut and install a new cotter pin.
Torque: 600 kg-em (43 ft·lb, 59 N·ml
4. CONNECT KNUCKLE ARM TO SHOCK ABSORBER
Place the shock absorber assembly in position and connect
the knuckle and with the
two
bolts. Torque the bolts.
Torque: 1,000 kg-em (72 ft·lb, 98 N·m)
5. INSTALL TIRE AND LOWER VEHICLE
6. TORQUE BOLT HOLDING LOWER ARM TO CROSS.
MEMBER
After bouncing the vehicle to settle the suspension, torque
the bolt.
Torque: 1,100kg-cm (80 ft·lb. 108 N·ml
7. CHECK FRONT WHEEL ALIGNMENT AND SIDE SLIP
(See page FA-31