Toyota Celica Supra 1986 Service And Repair Manual page 228

CH-10
CHARGING SYSTEM - Alternator
...,,
..
ASSEMBLY OF ALTERNATOR
(See page CH-5)
1. INSTALL ROTOR TO DRIVE END FRAME
2. INSTALL REAR END FRAME
(a) Using a plastic hammer, light ly tap the rear end frame
onto the drive end frame.
(b) Install the four nuts.
3. INSTALL PULLEY
(a) Install the pulley to the rotor shaft by tightening the
pulley nut by hand.
(b) Hold SST A with a torque wrench and tighten SST B
clockwise to t he specified torque.
SST 09820-63010
Torque: 400 kg-em (29 ft-l b, 39 N -ml
(c) Check that SST A is secu red to the pulley shaft.
(d) As shown in the figure, mount SST C in a vise and
then install the alternator to SST C.
(e) To torque the pulley, nut t um SST A in the direction
shown in the figure.
Torque: 1,125 kg-em (81 ft·lb, 110 N-m)
(fl
Remove the alternator from SST C.
(g) Turn SST B and remove SSTs A and B.
4. INSTALL RECTIF I ER HOLDER
(a) Install t he four rubber i nsulators on the lead wires.
(b) Install the rectifier wi th lour screws .