Toyota Celica Supra 1986 Service And Repair Manual page 488

r--------------------~B~R ~ A~K~E ~ SY~S~T~E~M ~ ~M ~a ~ s~ w ~ r ~ C ~ y l~ in ~ ~ ~r ~ ----------------~B~R~ - 1~1
' -
\
•
·-
5. INSTALL RESERVOIR
(a) Install the reservoir on the master cylinder. Torque
the bolt.
Torque: 250 kg-em (18 ft·lb, 25 N-m)
(b) lnmlllhe strainer and cap.
6. I NSTALL ELBOW AND SNAP RING
7. CONNECT RESERVOIR HOSE
INSTALLATION OF MASTER CYLINDER
(See page BR-9)
1. CLEAN OUT GROOVE ON LOWER INSTAL LATION
SURFACE OF MASTER CYLINDER
2. CONFIRM THAT "UP" MARK OF MASTER CYLINDER
BOOT IS IN CORRECT POSITION
3. ADJUST LENGTH OF BRAKE BOOSTER PUSH ROD
BEFORE INSTALLING MASTER CYLINDER
(See
page
BR-1 2)
4. INSTALL MASTER CYLINDER
lnttall lhe
~
cylinder and gasket on the brake booster
wilh four nuts.
Torque: 130 kg-em (9 ft-lb, 13 N-m)
5. CONNECT TWO BRAKE TUBES
Using SST, connect two brake tubes to the outlet plugs.
SST 09751 -36011
Torque:
155 kg-em (1 1 ft-lb, 15 N-m)
6.
CONNECT LEVEL WARNING SWITCH CONNECTOR
7. ADJUST BRAKE PEDAL (See
page
BR-6)
8. FILL BRAKE RESERVOIR WI TH BRAKE FLUI D AND
BLEED BRAK E SYSTEM (See page BR-7)