Toyota Celica Supra 1986 Service And Repair Manual page 252

MT-12 MANUAL TRANSMISSION - W58 Transmission
13. REMOVE OUTPUT SHAFT REAR BEARING AND Flfllt
GEAR
{a} Using two screwdrivers and a hammer, tap out
snap ring.
lb) Using SST, remove the rear bearing and 5th gear.
SST 09312-2001 1
14. REMOVE REVERSE GEAR
{a) Using snap ring pliers. remove the snap ring.
(b) Using SST, remove the reverse gear.
SST 09950-20016
1 5. REMOVE CENTER BEARING RETAINER
tal Using a torx socket wrench, unscrew the torx screws J
and remove the retainer.
(b) Using snap ring pliers, remove the snap ring.
16. REMOVE OUTPUT SHAFT AND COUNTER GEAR AS
UNIT FROM INTERMEDIATE PLATE
(a) Remove the output shaft, input shaft and counter
as a unit from the intermediate plate by pulling on
the
counter gear and tapping on the intermediate plate
with
a
plastic hammer.
(b) Remove the input shaft from output shaft.
1 7. MEASURE EACH GEAR THRUST CLEARANCE
Using a feeler gauge. measure the thrust clearance of eacll
gear.
Standard clearance: 0.10 - 0.26 mm
10.0039 - 0.0096 ln.)
Maximum cleerence: 0.30 mm (0.0118 in.)