Toyota Celica Supra 1986 Service And Repair Manual page 752

AIR CONDITION ING SYSTEM - Compressor
AC-31
(d) Install the rear valve plate together with the discharge
valve over
the
pins on the rear cylinder.
NOTE: The rear valve plate is marked ''R".
(e) Lubricate the guket with compressor oil . Install the
gasket on the valve plate.
2. INSTALL REAR HOUSING ON REAR CYLINDER
3.
INSTALl FRONT VALVE PLATE ON FRONT
CYLINDER
(al Install the
twO
pins in the front cylinder.
(b) lubricate a new O·ring with compressor oil. Install
the O·ring in the rear housing.
(c)
Install the front suction valve over the pins on the
fron t cylinder.
ld) Install the front valve plate together with the diSo
charge valve over the pins on the front cylinder.
NOTE : The front valve plate is marked with an
"F".
(e) lubricate gasket with compressor oil. Install the
gasket
on
the valve plate.
4 . INSTALl FRONT HOUSING ON FRONT CYLINDER
AND TIGHTEN SIX THROUGH BOLTS
Using
SST
and a torque wrench, gradually tighten the six
through bolts in
two
or three passes.
SST 07110-51050
Torque: 260 kg·cm (19 ft·lb, 26 N·ml
5 . INSTALL SHAFT SEAL
(a) Fit the shaft seal to SST.
SST 07114·15010