Toyota Celica Supra 1986 Service And Repair Manual page 531

l !
u
STEERING - Power Steering
SR·23
....
•
ASSEMBLY OF POWER STEERING PUMP
(See
pogo SR-19)
1. INSTALL SPRING AND FLOW CONTROL VALVE
NOTE: Be
sure
the letter inscribed on
the
flow control
valve matches the letter
s~mped
on the rear of the pump
body.
Inscribed mark: A.
B.
C, D. E or F
2. INSTALL PRESSURE PORT UNION
Install and torque the union.
Torque: 700 kgo<:m (51 ft·lb. 69 N·m)
3. INSTALL FLOW CONTROL SPRING SEAT
(a) Temporarily install
a
suitable bolt to the spring seat.
(b) Push in the bolt and install the snap ring with snap
ring pliers.
(c) Remove the suitable bolt.
4 . INSTALL ROTOR SHAFT TO FRONT HOUSING
Install the rotor shaft into the front housing by
tapping it
in with a plastic harrvner.
5. INSTALL SNAP RING
Using snap ring pliers. install the snap ring to the front
housing .
6. INSTALL OIL SEAL
(a) Apply a light coat of MP grease to a new oil seal lip.
(b) Using SST and a hammer. install the oil seal.
SST 09608·30012 (09608.Q4030)
7. INSTALL D-RING
8. INSTALL STRAIGHT PINS
9 . INSTALL CAM RING
Align the fluid passage• of t he cam ring and front housing.
end install the cam ring .