Toyota Celica Supra 1986 Service And Repair Manual page 422

FRONT AXLE AND SUSPENSION - Front Suspension
Stabilizer Bar
(See
page FA-14)
REMOVAL OF STABILIZER BAR
1. REMOVE ENGINE UNDER COVER
FA-19
2. DISCONNECT STABILIZER BAR FROM LOWER ARMS
3. REMOVE BOTH STABILIZER BAR BRACKETS FROM
STRUT BAR BRACKETS
4. REMOVE STRUT BAR WITH STRUT BAR BRACKET
ON ONE SIDE
(a} Remove the two nuts, an·d disconnect the strut bar
from the lower arm.
(b} Remova the four strut bar bracket bolts.
5. REMOVE STABILIZER BAR
Pull out the stabilizer bar through the strut bar bracket
hole.
INSTALLATION OF STABILIZER BAR
1. INSERT STABILIZER BAR THROUGH STRUT BAR
BRACKET HOLE
2. INSTALL STRUT BAR BRACKET
3.
4.
Install the strut bar bracket and torque the bolts.
Torque: 475 kg-em (34 ft·lb, 47 N-m)
INSTALL STRUT BAR TO LOWER ARM
Install the strut bar and torque the nuts.
Torque: 670 kg-cm
(48
ft-lb, 66 N -m)
INSTALL STABILIZER BAR ON BRACKETS
Place the stabilizer bar in position and install both
stabilizer bushings and brackets on the strut bar brackets.
Torque the bol ts.
Torque: 130 kg·cm (91t-lb, 13 N-m}
5. CONNECT STABILIZER BAR TO LOWER ARMS
Connect the stabilizer bar on both sides to the lower arms
with bolts, cushions and nuts as shown. Torque the nuts.
Torque: 180 kg-em (13 ft-lb, 18 N -ml
6.
INSTALL ENGINE UNDER COVER
7. CHECK FRONT WHEEL ALIGNMENT
(See
page F A-3)