Toyota Celica Supra 1986 Service And Repair Manual page 329

AT-54
~
AUTOMATIC TRANSMISSION - Component Groups (Oil Pump)
" m
"m
..
_
C41l&
ASSEMBLY OF OIL PUMP
(See page AT -52)
1. INSTALL DRIVEN GEAR AND DRIVE GEAR AND SET PUMP
BODY ON TORQUE CONVERTER
Make sure the top of the gears is facing upward.
2. LOOSELY INSTALL PUMP COVER
Align the bol t holes and drop the pump cover into place.
Install t he si x bolts with wave washers finger tight.
3 .
ALIGN PUMP AND PUMP COVER
Install the SST around the pump and cover.
Tighten SST to align the pump and cover.
SST 09350-20013 1 09363-20010)
4. TIGHTEN SIX PUMP COVER BOLTS
Torque: 75 kg-em (65 inAb. 7.4 N·ml
5. INSTALL TWO OIL SEAL RINGS ON PUMP COVER
Spread the rings apart and slide them into the groove.
Hook both ends by hand.
W ipe off excess petroleum jelly.
6 . INSTALL NEW 0 -RING ON PUMP COVER
Make sure a new O·ring is not twisted and is fully seated
in the groove .
7. CHECK PUMP DRIVE GEAR ROTATION
Turn the drive gear with SST and make sure that it rotates
smoothly.
SST 09350-20013 !09397-220201