Toyota Celica Supra 1986 Service And Repair Manual page 694

BODY - Windshield
80·25
7. INSPECT FOR LEAKS A ND REPAIR
(a) Perform a leak
tJ!st
after hardening t ime has elapsed.
(b) Seal any In k with adhesive or au to glass sealer.
Part No. 08833 . .()0030 or equivalent
CAUTION : Weit
It
leliSt twice the hardening time before
driving the car.
8. CONNECT RADIO ANTENNA CONNECTOR
9. INSTALL OUTSIDE MOULDING
(a) Using a knife, remove the adhesive around the
installation area of the clips.
(b) Apply adhesive at the installation area of the clips.
NOTE: Loosely install the clip and confinm that the clip
arm is not protruding above
the
surface.
(c) Install the clips into the moulding.
When installing the moulding, be sure thot the clips
and fasteners on the body side
do
not make contact.
(d) Install the outside moulding.
• Install lower mou lding.
• Fit on the upper moulding and
tap
by hand to
fasten the fasteners.
• Install the side moulding a nd slide down the
moulding.
• Install the corner join t mould ing.
10. INSTALL FOLLOWING PARTS:
(a) Roof hudlinor front trim
{b) Inner rear
\liew
mlrrOf
11. INSTALL WIPER ARM
12. INSTALL FRONT PILLAR GARNISH