Toyota Celica Supra 1986 Service And Repair Manual page 487

BR· 10 BRAKE SYSTEM -Master Cylinder
5. REMOVE PISTON STOPPER BOLT
Using a screwdrive-r. push the pistons in all the way and
remow the piston stopper l>olt.
6 .
REMOVE TWO PISTONS AND SPRINGS
{a) Using snap ring pliers, remow the snap ring.
{b)
Remow two pistons and springs from the master
cylinder.
NOTE: It may
be
necessary to inject compressed air in
the check valve hole to force out the No. 2 piston.
ASSEMBLY OF MASTER CYLINDER
{See
page BR·9)
1. APPLY L ITHIUM SOAP BASE GLYCOL GREASE
TO RUBBER PARTS OF PISTON
2. INSTALL TWO SPRINGS AND PISTONS
CAUTION: Be careful not to damage the rubber Iipson
the pistons.
(a) Insert two springs and pistons in the master cylindo;
housing as shown.
(b) Using snap ring pliers, install the snap ring.
3. INSTALL PISTON STOPPER BOLT
Using screwdriver, push the pistons in all the way
ai\d
install the piston stopper l>olt. Torque the bolt.
Torque: 100 kg-<:m (7 ft·lb, 10 N.m)
4. INSTALL TWO OUTL ET PLUGS
Torque plugs.
Torque: 450 kg-em (33 ft·lb, 44 N.m)