Toyota Celica Supra 1986 Service And Repair Manual page 425

REAR AXLE AND SUSPENSION- Rear Wheel Alignment RA-3
---
.....
REAR WHEEL ALIGNMENT
1. MAKE FOLLOWING CHECKS AND CORRECT ANY
PROBLEMS
(a) Check the tires for wear and proper inflation.
Cold tire inflation pressure:
kg/em'
(pol, kPal
Tire Front
Rtat
225/60 HR 14
' .9 (27, 186) 1.9 (27,188)
(b) Check the rear wheel bearings for looseness.
(c) Check wheel runout.
Lateral runout: Less than 1.0 mm (0.039 in.)
(d) Check the rear suspension for looseness.
(e)
Check that the rear absorbers work properly by the
standard bounce test.
2.
MEASURE VEHICLE HEIGHT
Vthiclt htigllt
mm (in.)
Tire
Front (AI
R .. r
(8)
223.0 283.0
225/60 HR 14
(8.780)
(10.354)
I
,.~~~
A If height of the vehicle is not as specified, try to level the
vehicle by shaking it down.
If
the height of the vehicle is
still not correct, check for bad springs and worn or loose
suspension parts.
3. INSTALL WHEEL ALIGNMENT EQUIPMENT
Follow the specific in. s tructions of the equipment manu-
facturer.
4 . INSPECT CAMBER
Inspect the camber with a wheel alignment tester.
Inspection standard : - 10' • <l5'
Adjuttme. n t stand.rd: - 10'
i
30'
Left-right error 20'
If camber is out of tolerance, Inspect and replace damaged
or worn rear suspension parts.