Toyota Celica Supra 1986 Service And Repair Manual page 312

AUTOMATIC TRANSMISSION - On-Vehicle Repair
AT-37
Painted Mark
(Wio jth: 4 m m)
0.8 - 1.5
mm
Rubber Soot {0.031 _ 0 .059 in.) Outer·
Cable
()Jit»l ,
3. REMOVE VALVE BODY (See page AT·321
4. PUSH THROTTLE CABLE OUT OF TRANSMISSION CASE
Using a 10-mm socket. push the throttle cable out.
INSTALLATION OF THROTTLE CABLE
1. INSTALL CABLE IN TRANSMISSION CASE
Be sure to push it in all the way.
2. INSTALL VALVE BODY (See page AT·341
3. IF THROTTLE CABLE IS NEW. PAINT MARK ON INNER
CABLE
NOTE: New cables do not have a cable stopper installed.
Therefore, to make adjustment possible, paint a mark as
described below.
(al Pull the inner cable lightly until slight resistance is felt,
and hold it.
(b, Paint a mark as shown, about 4 mm (0.16 in .} in
width.
4. CONNECT THROTTLE CABLE
(a) Connect the cable to the throttle linkage.
(b) Connect the cable housing to the bracket on the valve
cover.
5. ADJUST THROTTLE CABLE (See page AT·61
6. INSTALL AIR CLEANER
7. TEST DRIVE VEHICLE
REMOVAL OF PARKING LOCK PAWL
1. REMOVE VALVE BODY (See page AT-321
2. REMOVE PARKING LOCK PAWL BRACKET
Remove the two bolts and the bracket.