Toyota Celica Supra 1986 Service And Repair Manual page 411

FA-8 FRONT AXLE AND SUSPENSION - Front Axle Hub
MP
MP Grease
Inner
Outer
Bearing Bearing
cap
H ub
154t J
ASSEMBLY OF FRONT AXLE HUB
(See
page FA-6)
1. PACK BEARINGS WITH MP GREASE
(a) Place MP grease in the palm of your hand.
(b) Pack grease into the bearing, continuing until
tho!
grease oozes out from the other side.
(c) Do the same around the bearing circumference.
2.
COAT INSIDE OF HUB AND CAP WITH MP GREASE
3.
INSTALL INNER BEAR ING AND OI L SEAL
Place inner bearing in to the hub. Using SST, drive the oil
seal into the hub. Coat the oil seal with MP grease.
SST
09608-30022 (09608-0501 0, 09550.00050)
4. INSTALL AXLE HUB ON SPINDLE
(a) Place the axle hub on the spindle.
(b) Install the outer bearing and thrust washer.
5.
ADJUST PRE LOAD
(a) Install and torque the nut.
Torque: 300 kg-em (22 ft·lb, 29 N-m)
(b) Turn the hub right and left
two
or three t imes
to
allow the bearings to settle.
(c)
Loosen the nut
so
thoro is
0.5 - 1.0
mm
(0.020-
0 .039
in.) play in the hub axial direction.
(d) Using a spring tension gauge, measure the rotation
friction force of the oil seal.
(e) Using a socket in your hand, tighten the nut as tight
as possible.
( f1
Check the preload.
Preload :
In addition t o rotation friction force of the oil seal
0 - 1,050
g
(0- 2.31b, 0 - 10
Nl