Toyota Celica Supra 1986 Service And Repair Manual page 539

Q
~~
I
ssr ........._
.
n~
STEERING -Power Steeri ng
SR-31
SST""'
IlL
l
S~· A
Z56&1 ll112
INSPECTION OF GEAR HOUSING
1. INSPECTION CONTROL VALVE
(a) Remove the oontrol valve with pinion from the yoke
housing.
(b) If necessary, replace the control valve assembly.
2. INSPECT STEERING RACK RUNOUT
Runout: Limit 0.3 mm (0.012 in.)
REPLACEMENT OF GEAR HOUSING
IF NECESSARY, REPLACE FOLLOWING PARTS:
1. 01 L SEAL FOR RACK HOUSING
(a) Remove the oil seal with a screwdriver.
(b) Using SST, install the new oil seal.
SST 09620.30010 109631·00020)
SST 09630.24013 (0963 1·24070)
2. 01 L SEAL FOR CYLINDER HOUSING
(a) Using SST, drive out the oil seal.
(b) Using SST and a hammer, install a new oil seal.
SST 09620·30010 (09625·30010, 09631 ·00020)
• Install the new oil seal.
• Place the spacer on the oil seal.
• Drive in the oil seal over the spacer until the round
surface of SST is flush wi th housing surface.
3. OIL SEAL AND BEARING FOR CONTROL
VALVE HOUSING
{a) Remove the snap ring.
{b) Remove the bearing and oil seal with brass bar.