Replacement Of Ou Sealo - Toyota Celica Supra 1986 Service And Repair Manual

EM-68
SST
ENGINE MECHANICAL - Cylinder Block
Fron t ~
lM IMi l ... H t.
tWINt
lbl Drive in tl\e bushing from tl\e inside of the block with
a suitable tool.
NOTE: The oil hole should
be
positioned toward the crank·
shaft side.
lei Make sure the front mark of the bushing is positioned
t oward the f ront of block.
REPLACEMENT OF OIL SEALS
NOTE: There ore two ways of oil seal replaument.
1. IF TIMING BELT CASE IS RE. M OVED FROM CYUNDER
BLOCK !Replacement of front
oil seal and pump drtvo ol
aNI I
fa) Using a screwdrJvor, remove the oil seel.
lb) Apply
M
P grooso to the oil seal lip.
lei Using SST, install the new oil seal.
SST
09214"4 1010
and
09506-3501 0
2 . IF REAR OIL SEAL RETAINER IS REMOVfD FROM
CYLINDER BLOCK (Replloeement o f rear o1 seoll
(a) Using a screwdrivet. remove the oil see1.
lbl Apply MP grease to the oil seal lip.
lei Using SST, install the new oil seal.
SST 09223·41 020
3 .
IF TIMING BELT CASE IS INSTALLED ON CYLINDER
BLOCK IReplecomont of front ol seal)
lal Using SST, remove tl\e front oil seal.
SST 09308·10010
(b) Appl y MP grease to the oil seal lip.
(cl Using SST, onuall the new oil seal.
SST 09214-41010 ond 09506-35010
•
I