Toyota Celica Supra 1986 Service And Repair Manual page 319

AT-44
AUTOMATIC TRANSMISSION - Removal of Transmission
16. REMOVE REAR SUPPORT MEMBER
(a) Remove the ground cable.
(b) Install a wooden block between cowl panel and
cylinder head rear end to prevent damage to the heater
hose.
(cJ Remove the eight bolts, and remove the rear suppM
member.
17. REMOVE ENGINE UNDER COVER
18. REMOVE SIX TORQUE CONVERTER MOUNTING BOLTS
Turn the crankshaft to gain access to each bolt.
Remove the six bolts.
19. INSTALL GUIDE PIN IN TORQUE CONVERTER
Install the guide pin in one of the torque convener
bolt
holes.
If necessary. a guide pin can be made by cutting off
tht
head of a bolt.
20. REMOVE TRANSMISSION HOUSING MOUNTING BOLTS
(al Remove the starter.
(b) Remove the transmission housing mounting boll$.
21 . PRY ON END OF GUIDE PIN TO BEGIN MOVING
TRANSMISSION WITH CONVERTER TOWARD REAR
The guide pin helps keep the converter with the trans·
mission.
22 . REMOVE TRANSMISSION ASSEMBLY
Draw out the transmission down and toward the rear.
CAUTION:
Be careful not to snag tho throttle cable or,..,.
tral start switch cable. Keep tho oil pan positioned
downward .
23. PLACE PAN UNDER CONVERTER HOUSING, AND
REMOVE CONVERTER
Pull the converter straight off. and allow the fluid to drain
into the pan.
24. REMOVE FILLER TUBE
26. REMOVE REAR TRANSMISSION MOUNT WITH GROUND
STRAP