Toyota Celica Supra 1986 Service And Repair Manual page 691

80·22
Fastener
BODY - Windshield
5.
REMOVE CLIPS
Be C4reful not to damage the clips when removing them
around the glass.
NOTE: Do not remove fasteners.
If any fastener is deformed, replace it.
6. REMOVE WINDSHIELD GLASS
(a) Push
piano wire through from the interior.
(b) Tie both wire ends to a wooden block or equivalent
CAUTION: When separating, take care not to damage
the paint and interior and exterior ornaments. To pr8Y8nt
scretching the safety pad when removing the windshield,
place a plastic sheet between the piano wire and
safaty
pad .
(c) Cut the adhesive by pulling the piano wire around it.
(d) Remove the glass.
CAUTION: Cut off the glass, teeving as much of
me
urethane !eyer on the body as possible.
INSPECTION AND CLEANING
1. CLEAN CONTACT SURFACE OF BODY
(a) Remove any dam remaining on tho body.
NOTE: Leave as much urethane layer on the body
as
possible.
{b) Clean the cutting surface of the urethane gum with a
piece of cloth saturated in solvent (alcohol).