Toyota Celica Supra 1986 Service And Repair Manual page 492

\
BRAKE SYSTEM - Front Brake
3. LIFT UP CYLINDER
(a) Lift up the cylinder.
BR·15
(b) Insert a bolt into the torque plate hole to secure the
cylinder.
4.
REMOVE PADS AND ANTI-SQUEAL SHIM
5. · REMOVE ANTI·RATTLE SPRINGS, PAD GUIDE
PLATES AND SUPPORT PLATE
6.
INSTALL NEW PAD SUPPORT PLATE. NEW PAD
GUIDE PLATES AND NEW ANTI·RATTLE SPRINGS
7. PUSH PISTON INTO CYLINDER
8. INSTALL NEW PADS AND NEW ANTI·SOUEAL SHIM
(a) Install the pads onto each spring.
NOTE: Install the outside pad
so
the wear indicator is at
the top side.
CAUTION: Do not allow oil or
grease
to touch the rub·
bing face.
(b) Install the anti-squeal shim toward the inside of the
pad.
9. LOWER CYLINDER
Remove the bolt from the torque plate and lower the
cylinder.
NOTE: Insert the cylinder carefully
so
the boot is not
wedged.
10. INSTALL CYLINDER INSTALLATION BOLT
Install and torque the cylinder installation bolt.
Torque: 200 kg·cm (14 ft·lb, 20 N-m)
11. FILL BRAKE FLUID