Toyota Celica Supra 1986 Service And Repair Manual page 546

SR·38
S T
Straight Line
STEERING -Power Steering
.....
15. INSTALL SEAT AND RACK GUIDE
16. INSTALL RACK GUIDE SPRING AND CAP
(a) Install the rack guide sPring.
(b) Coat liquid sealer onto the screw surfaoe of the cap.
(c) Using SST, install the rack guide sPring cap.
SST 09612·24012 (09612·10021)
17. ADJUST TOTAL PRELOAD
(a) Tighten the rack guide spring cap with SST ard
torque it.
Torque: 250 kg·cm (18 fHb, 25 N-m)
(b) Using SST, return the rack guide spri ng cap 90' .
(c) Using SST, measure the pr&load.
SST 09616·00010
Preload (turning): 9- 12 kg·cm
(7 .8 - 10.4 in.· lb, 0.9 - 1.2 N·m)
If incorrect, readjust.
18. INSTALL RACK GUIDE SPRING CAP LOCK NUT
(a) Coat liqu id seal er onto the lock nut and gear housi14
contact surfaces.
(b) Tighten the rack guide spring cap lock nut and torquo
it with SST.
SST 09612·24012 109612· 10021, 09617·24020)
Torque: 700 kg-em (51 ft·lb, 69 N-m)
lc) Recheck the total preload.
If incorrect. readjust.
Preload (turning): 9 - 12 kg·cm
(7.8 - 10.4 in.·lb, 0.9- 1.2 N-m)
19. INSTALL DUST COVER
20. INSTALL RACK BOOTS, CLAMPS AND CLIPS
(a) Insure that the tube hole is not clogged wit h grease.
NOTE : If the tube hole is clogged, the pressure inside
the boot wi ll change alter it is assembled and the
hand~
turned.
(b) Install boots.
NOTE: As the left and right boots are different, be careful
not to interchange them.