Toyota Celica Supra 1986 Service And Repair Manual page 382

AUTOMATIC TRANSMISSION - Assembly of Tnlnsmisslon AT·107
6. INSTALL REACTION PLATE
Position the notched tooth of the reaction plate toward the
valve body side of the case . Push it into place.
NOTE : The reaction plate is correctly installed if the snap
ring groove is fully visible.
7.
INSTALL SNAP RING
Use a large screwdriver to compress the snap ring. Push
It into place by hand. Work around the case. Visually check
to make sure that the ring is fully seated. Make sure that
the ends of the snap ring are
between
t. h e lugs.
8 . PUSH CENTER SUPPORT ASSEM8L Y INTO CASE
Align the oil hole and bolt hole of the center support with
those of the body side and insert.
9 .
INSTALL TWO CENTER SUPPORT BOLTS WITH WAVE
WASHERS
Align the center support with holes in the case and install
the two bolls linger tight.
10. INSTALL REAR CLUTCH IN CASE
Rotate the clutch to mesh the hub with the center support.
11 . CHECK FOR CORRECT INSTALLATION OF REAR CLUTCH
lithe rear clutch is fully meshed with the center support,
the splined center of the clutch w ill be flush with the end
of the sun gear shaft.