Toyota Celica Supra 1986 Service And Repair Manual page 352

AUTOMATIC TRANSMISSION -Component Groups (Planet ary Gear Output Shaft) AT-77
"' " '
ATotJ2
14.
INVERT INTERMEDIATE SHAFT AND REMOVE SET RING
15.
REMOVE REAR PlANETARY RING GEAR AND BEARING
" RACE FROM INTERMEDIATE SHAFT
1
Note the position of the race.
'1'"!'1 ....
~
INSPECTION OF PLANETARY GEAR OUTPUT
SHAFT
INSPECT DISK, PlATE AND FLANGE
Check that the sliding surface of disc is not worn or burnt.
If the disc is worn or burnt, replace all discs .
Then check that the sl iding surface of plate is not worn
or burnt.
If necessary, replace them.
NOTE: Do not allow the discs to dry out.
Prepare new discs by soaking them at least two hours in
ATF.
ASSEMBLY OF PLANETARY GEAR OUTPUT
SHAFT
(See pege AT-751
1 . INSTALL THRUST BEARING RACE AND REAR
PLANETARY RING GEAR ON INTERMEDIATE SHAFT
Slip the thrust bearing race and ring gear onto the shaft
with the exterio r spline.s up, as shown.
2. INSTALL SET RING ON INTERMEDIATE SHAFT
Push down and wind the set ring into place. Check to make
sure
it
is secure.
3. TURN OVER INTERMEDIATE SHAFT AND INSTALL
THRUST BEARING AND RACE
Make sure the flat side of the race is against the bearing.
4. INSTALL PINION GEAR ASSEMBLY AND STEEL THRUST
WASHER ON REAR PLANETARY CARRIER
Install the washer with the lugs down. f itting into the rear
planetary gear carrier.
CAUTION: Make sure the different lug shapes match the
openings on the plate.